Dispose of antique baby cribs with decorative cut-outs, corner posts or lead paint. The space between the slats should be no more than 2-3/8 inches apart too stop infants from getting their head stuck betwixt those. Cribs devised after 1974 must meet this and other strict safety standards. The corner posts should be the same height as the final panels or less than 1/16 of an inch higher than the final panels.
No cut-out areas on the headboard or foot board so a baby's head cannot obtain trapped. The top rails of crib sides, in their raised position, should be at least 26 inches on top of the top of the mattress support at its lowest position.
As shortly as the child can pull himself to a standing position, set and keep the mattress at it is lowest position. Cease using the crib once the height of the top rails is lesser than three-fourths of the child's height.
Mattress
The mattress should fit snugly next to the crib then that there is any gap. If two adult fingers can be placed between the mattress and the crib, the mattress should be now replaced. Do not use plastic packaging materials, such as dry cleaning bags, as mattress covers. Plastic film could cling to children's faces and should never be in or next to the crib.
Put your baby to snooze on his or her back or side in a crib with a firm, flat mattress and nay soft bedding underneath. Speak too your paediatrician about which sleeping position is greatest for your child.
Crib Hardware
The drop side(s) of the crib should require 2 distinct actions or a minimum force of 10 pounds with one action to release the latch or the locks
too prevent accidental release by the child.
The crib hardware should be checked for disengaged, broken, bent or loose pieces. Special checks should be created of the mattress support hangers and brackets so they cannot fall. The hardware and the crib should be smooth and free of sharp edges, points and rough surfaces.
Crib Accessories
Bumper pads should conceal the total internal perimeter of the crib and tie or snap in place. Bumper pads should have at least six straps or ties and any amount excess length of straps or ties should be sever off. Bumper pads should never be used in lieu of proper spacing between the slats and should be removed from the crib as soon as the child canst pull himself to a standing position.
Teething rails that are damaged should be fixed, replaced or removed now. To prevent doable entanglement, mobiles and crib gyms, which are meant to be hung over or across the crib, should be removed when the child is five months old or when he begins to push up onto hands and knees or can pull himself up? Keep the crib clear of plastic sheets, pillows, and large stuffed animals or toys. Those canst be suffocation hazards or can enable youngsters to climb out of the crib. Any part cloth or vinyl items that are loose or torn should be replaced or repaired immediately.
Crib Environment
Do not place crib next to a window. Drapery and blind cords pose an entanglement hazard and window screens are not intended to preserve a child in, only insects out. Install smoke detectors. Follow the manufacturer's directions for placement. Check at least once a month too makes sure battery and smoke indicator are in ok working condition.
Author Resource:-
Uchenna Ani-Okoye is an internet marketing advisor
For more information you can visit convertible baby cribs at http://www.convertiblebabycribs.info
![[Valid RSS feed]](http://cdnimages.articlefriendly.net/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
